INSTRUCTIONS

 

Preparation

The better the preparation, the better the finish. The surface must be clean, dry, dust and dirt free. In the vast majority of cases, our products can be applied over the top of existing finishes. For best results, apply to a well prepared bare surface. We recommend two or more coats when first applying our treatments. Drying times vary depending on the preparation beforehand.

When applying to wood, always try and sand down the surface before applying the treatment. If the wood suffers from grain lift after application, allow the treatment to dry and sand down the offending area and reapply.

Wax Oil Treatment

 

Apply sparingly to a prepared surface using a folded kitchen paper towel or a soft brush and allow the treatment to absorb into the surface. Leave for a minimum of 2 hours and wipe off any excess. Ideally leave to dry overnight. Then buff with a clean paper kitchen towel or a clean soft cloth for a beautiful sheen finish.

Liquid Wax Oil Treatment

 

This is a concentrated product so give the bottle a thorough shake before using. Apply the treatment very sparingly to a prepared surface using a folded kitchen paper towel or a soft brush and allow the liquid wax oil to absorb into the surface. Leave for a minimum 2 hours and wipe of any residue and leave to dry overnight. Buff up with a clean paper kitchen towel or a clean soft cloth for a beautiful sheen finish.

 

Pure Mineral Oil

Our mineral oil is very easy to use. Simply apply sparingly using a folded paper kitchen towel or a soft brush. Allow the oil to absorb into the surface. Once dry, wipe over with a clean paper kitchen towel or a clean soft cloth.

 

Pure Mineral Oil & Beeswax Blocks

 

It is so quick and easy to apply. Apply the mineral oil to the surface using a folded paper kitchen towel or a soft brush and leave for 2 minutes. Then rubs beeswax block over the surface ensuring a good layer of wax is evenly spread over the area treated. Leave for a minimum of 2 hours and wipe off any residue. Ideally leave overnight to fully dry and buff up using a clean paper kitchen towel or a clean soft cloth.

Alternatively, mix the mineral oil and beeswax together by gently heating until the wax is melted. Give the mix a good stir. Do not leave unattended and make sure it is on a low heat. If you are using a microwave, only heat for 15 seconds at a time. Check the mixture and repeat if required. Apply using a folded paper kitchen towel or a soft brush. Leave for a minimum of 2 hours and wipe off any residue. Ideally leave overnight to fully dry and buff up using a clean paper kitchen towel or a clean soft cloth.

  • Facebook Social Icon
  • Twitter Social Icon

© 2018 Brandon Bespoke Ltd.